![]() Doesn't -2 mean that it's supposed to go 2 degrees past 90? It was all I could do to get it to 90 so there's no way. The published range of bevel is -2 to 47. Since the stop cam has a lot more room for adjustments, I'm pretty sure I shouldn't have to do that. Now it is exactly 90 but to do that it's really shoved against the fabric. I finally got it by shoving the handle as far as I could and locking it in, then doing the cut test. But when I brought it home and did the cut test, the two pieces rocked a little so it wasn't quite 90 degrees still. They brought me in back and showed me with a square that the blade was 90 degrees to the table. They took it in the back and fiddled with it, then told me it goes to 90 fine I had gone past it. I brought it to a Dewalt factory service center. But I'm using this just as a normal table saw. You have to keep in mind that this is a jobsite saw so most of the things that are a little off are fine for that purpose. I got this saw along with the rolling cart and that part works well. I have a tiny little area in my garage that I use as a workshop so I need tools that I can fold up and store out of the way.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |